DYNDNS COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
325
dyndns modify
Modify a dynamic DNS client.
SYNTAX:
dyndns modify name = <>
[intf = <{Internet|wan1}>]
[user = <string>]
[password = <password>]
[group = <>]
[mx = <string>]
[backmx = <{disabled|enabled}>]
[wildcard = <{disabled|enabled}>]
[offline = <{disabled|enabled}>]
[service = <{dyndns|statdns|custom|No-IP|
DtDNS|gnudip}>]
[status = <{disabled|enabled}>]
[trace = <{disabled|enabled}>]
where:
name The dynamic DNS client name. REQUIRED
intf The dynamic DNS client interface. OPTIONAL
user The username for dynamic DNS authentication. OPTIONAL
password The password for dynamic DNS authentication. OPTIONAL
group The dynamic DNS host group. OPTIONAL
mx The mail exchanger. OPTIONAL
backmx Set up the mail exchanger as a backup MX. OPTIONAL
wildcard Allow use of hostname wildcards. OPTIONAL
offline Set the host to offline mode. OPTIONAL
service The dynamic DNS service. OPTIONAL
status Enable/Disable the dynamic DNS client. OPTIONAL
trace Enable/Disable the verbose console logging for the dynamic
DNS client.
OPTIONAL
To Next Page
Loading...
Need help?
General
