IPSEC COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
641
ipsec connection modify
Changes a connection profile.
SYNTAX:
ipsec connection modify name = <>
[peer = <>]
[localnetwork = <{retrieve_from_server|
black_ip}>]
[remotenetwork = <{retrieve_from_server|
allocated_virtual_ip|black_ip}>]
[alwayson = <{disabled|enabled}>]
[descr = <{AES_SHA1_TUN|AES_MD5_TUN|
AES_SHA1_PFS_TUN|AES_MD5_PFS_TUN|
DES_SHA1_TUN|DES_MD5_TUN|AES_SHA1_Adv_TUN|
NullEnc_SHA1_TUN}>]
[options = <>]
[state = <{disabled|enabled}>]
where:
name The name of the connection profile to change. REQUIRED
peer Peer gateway profile. i.e. the gate to talk to. OPTIONAL
localnetwork Local trusted network (either a network attribute or a special
keyword for dynamic cases)
OPTIONAL
remotenetwork Remote trusted network (either a network attribute or a
special keyword for dynamic cases)
OPTIONAL
alwayson Is this connection be on at all time, provided IPSec is
enabled?
OPTIONAL
descr Up to 4 phase two (IPSec) security descriptors separated by
|
OPTIONAL
options Connection options. OPTIONAL
state Enable/disable this connection profile. OPTIONAL