ATM COMMANDS
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
61
atm oam cc send
Send CC activate/deactivate to connection.
SYNTAX:
atm oam cc send port = <{dsl0|dsl1|atm2|atm3|aal5|atm5} or
number>
vpi = <number{0-31}>
[vci = <number{0-511}>]
[span = <{segment|end2end}>]
[action = <{activate|deactivate}>]
[direction = <{source|sink|both}>]
where:
port The ATM port number. REQUIRED
vpi The Virtual Path Identifier. REQUIRED
vci The Virtual Channel Identifier. OPTIONAL
span Send CC action end2end or segment. OPTIONAL
action The CC action. OPTIONAL
direction Source, sink or both (default: both). OPTIONAL
To Next Page
Loading...
Need help?
General
