ETH COMMANDS
346
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
eth bridge dynvlan add
Add a dynamic VLAN membership entry.
SYNTAX:
eth bridge dynvlan add [id = <number{0-100000}>]
hwaddr = <masked-hardware-address>
vlan = <{default|wan|dmz|guest}>
[prio = <number{0-7}>]
[mode = <{none|vid|prio|both}>]
where:
id The id of the dynamic VLAN membership entry. OPTIONAL
hwaddr The (masked) ethernet MAC address of the dynamic
VLAN membership entry.
REQUIRED
vlan The VLAN for the dynamic VLAN membership entry. REQUIRED
prio The new port priority to be set. OPTIONAL
mode The flexiport mode of operation. OPTIONAL