ETH COMMANDS
472
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
eth switch qos weights
Configure the queue weights.
SYNTAX:
eth switch qos weights queue0 = <number{0-100}>
queue1 = <number{0-100}>
queue2 = <number{0-100}>
queue3 = <number{0-100}>
where:
queue0 Weight of queue 0 in WFQ (in %). REQUIRED
queue1 Weight of queue 1 in WFQ (in %). REQUIRED
queue2 Weight of queue 2 in WFQ (in %). REQUIRED
queue3 Weight of queue 3 in WFQ (in %). REQUIRED
To Next Page
Loading...
