IPSEC COMMANDS
670
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
ipsec peer options modify
Changes a peer options group.
SYNTAX:
ipsec peer options modify name = <>
[localaddr = <ip-address>]
[nat-t = <{enabled|disabled}>]
[dpd = <{disabled|enabled}>]
[dpd_idle_period = <number{10-3600}>]
[dpd_xmits = <number{1-5}>]
[dpd_timeout = <number{5-120}>]
[inactivity = <number>]
[nat-t_keepalive = <number>]
where:
name The name of the peer options group to change. REQUIRED
localaddr Selected black IP address of the local IPSEC gateway OPTIONAL
nat-t NAT Traversal support. OPTIONAL
dpd Enable/Disable the Death Peer Detection support. OPTIONAL
dpd_idle_period The number of seconds before the remote peer is
considered idle.
OPTIONAL
dpd_xmits The maximum number of Death Peer Detection
R_U_THERE messages before the remote peer is
considered as death.
OPTIONAL
dpd_timeout Number of seconds between retries if the Death Peer
Detection R_U_THERE message fails.
OPTIONAL
inactivity Inactivity timeout (seconds). OPTIONAL
nat-t_keepalive nat traversal keepalive interval (seconds). OPTIONAL
To Next Page
Loading...
Need help?
General
