NAT COMMANDS
790
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
nat config
Modify global NAT configuration.
SYNTAX:
nat config [trace = <{disabled|enabled}>]
[randomports = <{disabled|enabled}>]
where:
trace Enable/disable traces. OPTIONAL
randomports Enable/disable randomization of port translations. OPTIONAL
To Next Page
Loading...
Need help?
General
