ROUTER COMMANDS
894
E-DOC-CTC-20100729-0006 v3.0.Copyright 2011Technicolor. All rights reserved.
This document contains Technicolor proprietary and confidential information. Passing on and copying of this document, use,
extraction and communication of its contents, is not permitted without written authorization from Technicolor.
router rip debug traceconfig
Configures the RIP daemon tracepoint.
SYNTAX:
router rip debug traceconfig [all = <{disabled|enabled}>]
[state = <{disabled|enabled}>]
[normal = <{disabled|enabled}>]
[policy = <{disabled|enabled}>]
[task = <{disabled|enabled}>]
[timer = <{disabled|enabled}>]
[route = <{disabled|enabled}>]
[reqrecv = <{off|on|detailed}>]
[resprecv = <{off|on|detailed}>]
[otherrecv = <{off|on|detailed}>]
[reqsend = <{off|on|detailed}>]
[respsend = <{off|on|detailed}>]
[othersend = <{off|on|detailed}>]
where:
all Enable/Disable tracing of all events related with RIP OPTIONAL
state Enable/Disable tracing of protocol state transitions OPTIONAL
normal Enable/Disable tracing of normal protocol occurrences OPTIONAL
policy Enable/Disable tracing the policy functions OPTIONAL
task Enable/Disable tracing the grp processing associated wiht
RIP
OPTIONAL
timer Enable/Disable tracing the timer usage of RIP OPTIONAL
route Enable/Disable tracing the RIB table changes for routes
installed by RIP
OPTIONAL
reqrecv Specifies the level of tracing the sent 'RIP request' packets OPTIONAL
resprecv Specifies the level of tracing the received 'RIP response'
packets
OPTIONAL
otherrecv Specifies the level of tracing of any other type of received
RIP packet
OPTIONAL
reqsend Specifies the level of tracing the sent 'RIP request' packets OPTIONAL
respsend Specifies the level of tracing the sent 'RIP response' packets OPTIONAL
othersend Specifies the level of tracing of any other type of send RIP
packet
OPTIONAL
To Next Page
Loading...
Need help?
General
