LPADDR
6-129
LPADDR Set the AMODE Bit
SYNTAX OPTIONS OPCODE OBJMODE RPT CYC
LPADDR 0101 0110 0001 1110 X − 1
Note: LPADDR is an alias for the SETC AMODE Operation.
Operands None
Description Set the AMODE status bit, putting the device in C2xLP compatible
addressing mode (see Chapter 5).
Note: This instruction does not flush the pipeline.
Flags and
Modes
AMODE
The AMODE bit is set.
Repeat This instruction is not repeatable. If this instruction follows the RPT
instruction, it resets the repeat counter (RPTC) and executes only once.
Example
; Execute the operation ”VarC = VarA + VarB” written in C2xLP syntax:
LPADDR ; Full C2xLP address compatible mode
.lp_amode ; Tell assembler we are in C2XLP mode
LDP #VarA ; Initialize DP (low 64K only)
LACL VarA ; ACC = VarA (ACC high = 0)
ADDS VarB ; ACC = ACC + VarB (unsigned)
SACL VarC ; Store result into VarC
C28ADDR ; Return to C28x address mode
.c28_amode ; Tell assembler we are in C28x mode
To Next Page
Loading...
Need help?
General
