CUTTING UNIT
4262930-Rev A 8-7
8
Scalping
NOTE: One cutting unit width shown. Arrow indicates
direction of travel.
Scalping is a condition in which areas of grass are cut
noticeably shorter than the surrounding areas, resulting in
a light green or even brown patch. This is usually caused
by an excessively low height-of-cut setting and/or uneven
turf.
Probable Cause Remedy
HOC (height-of-cut) settings are lower than normal. Check and adjust the HOC settings. (See “Height-of-Cut
Adjustment (HOC)” on page 8-17.)
Turf too uneven for the mower to follow. Try a different mowing direction.
Incorrect bedknife for HOC. Install correct bedlknife for desired HOC. (See “Bedknife Backing
Assembly” on page 8-22.)
Cutting too much grass at one time. Mow more often.
Mowing (ground) speed is too fast. Reduce mowing (ground) speed.
TN0222
To Next Page
Loading...
