TOHATSU BFT75A - Page 42

2-23
dummyheaddummyhead
SERVICE INFORMATION
Clamp the remote control
cable harness or tiller
handle cable harness, and
indicator light harness.
FUEL PUMP (HIGH)
2P CONNECTOR
MAIN HARNESS
POWER TILT RELAY
3P CONNECTOR
FUSE CABLE 1P
CONNECTOR
NEUTRAL SWITCH 2P
CONNECTOR
Set the pump harness
above the power tilt
relay 3P connector wire
(Except LHGX type).
WIRE CLAMPER
PUMP HARNESS
POWER TILT
RELAY 1P
CONNECTOR WIRE
Tighten the bolt while
pushing the ground
terminal against the lug
on the crankcase.
LUG
HARNESS
BAND CLIP
REMOTE CONTROL CABLE
or TILLER HANDLE 14P
CONNECTOR
INDICATOR LIGHT
6P CONNECTOR
HARNESS
BAND CLIP
POWER TILT RELAY 3P
CONNECTOR WIRE
POWER TILT
RELAY GROUND
CABLE
HARNESS
BAND CLIP
POWER TILT RELAY
1P CONNECTOR
POWER TILT MOTOR
2P CONNECTOR
POWER TILT
RELAY
POWER TILT RELAY
2P CONNECTOR
HARNESS
BAND CLIP
FUSE CABLE 1P
CONNECTOR WIRE
HARNESS BAND CLIP
HARNESS
BAND CLIP
(Except LHGX type)
(Except LHGX type)
(Except LHGX type)
(Except LHGX type)
(Except LHGX type)
(Except LHGX type)
(Except LHGX type)
(Except LHGX type)
(Except LHGX type)
(Except LHGX type)