19-27
dummyheaddummyhead
CONTROLS
Remove the bolt [1] and height adjust block [2].
Remove the nut (small) [3] that tightens the steering bracket.
Remove the bolt [4], nut (large) [5], wave washer [6], distance collar [7], and washer (12 mm small) [8].
Remove the steering bracket [9] and washer (12 mm large) [10].
Check the steering handle bushings [11] mounted on the steering bracket installation part of the tiller handle for
wear, damage, or deformation. Replace the bushings with new ones if necessary.
Remove the grip rubber [1] and bolt [2].
[1]
[2]
[3]
[5]
[6]
[7]
[4]
[8]
[10]
[11]
[9]
[11]
To Next Page
