TOHATSU BFT75A - Page 565

19-28
dummyheaddummyhead
CONTROLS
Loosen the throttle friction grip [1] of the grip pipe [2],
and turn the grip pipe clockwise to remove it from the
tiller handle.
Remove the throttle friction grip [1], throttle friction pad,
[2] and the throttle friction block [3] from the grip pipe
[4].
• Except LHGX type:
Open the two harness bands [1] of the wire cover [2].
Remove the two screws [3], and remove the wire cover.
Remove the bolt [4] and the washer [5], and remove the
power trim/tilt switch [6].
Remove the switch grommet [7] and the switch holder
[8] from the power trim/tilt switch.
• LHGX type only:
Remove the bolt [4] and the washer [5], and remove the
switch holder [8].
Remove the switch hole grommet [9].
[2]
[1]
[1]
[2]
[4]
[3]
[1]
[2]
[3]
[5]
[4]
[8]
[7]
[6]
[9]