19-29
dummyheaddummyhead
CONTROLS
Remove the cap [1].
Loosen the socket bolt [2] by approximately 10 mm (0.4
in).
Remove the shift lever [3] from the tiller handle by
lightly tapping the bolt head with a plastic hammer.
Remove the socket bolt and the washer [4] from the
shift lever, and remove the lever stopper [5] and the
shift lever from the tiller handle.
Remove the O-ring [6] from the shift lever.
Check the bushing [7] for wear or damage and replace
it with a new one if necessary.
Remove the two bolt/washers [1] from the shift frame [2].
Remove the three bolts [3], three washers [4], and the guide plate [5], and then remove the throttle arm [6]/
throttle rod [7] and the shift frame as a set.
Remove the E-ring [8], and remove the throttle rod and the two washers [9].
Remove the steel ball [10] from the shift frame.
[1]
[2]
[8]
[9]
[7]
[3]
[4]
[6]
[10]
[9]
[5]
To Next Page
