Topcon KR-1W - Page 175

173
FUNCTION SETTING USING SETTINGS
SETTING REF/KRT DATA OUTPUT
When the is pressed, outputting measurement data to a connected PC,
while simultaneously printing with the internal printer, can be set to ON or OFF. Before ship-
ment, the default setting is OFF.
1 Tap the of the set item display "REF/KRT Data Output" of "NET-
WORK."
2 Tap the and select "ON" or "OFF."
3 Setting is complete.
SETTING THE KR-1W IP ADDRESS
The IP address of KR-1W can be set.
1 Tap the of the set item display "KR-1W IP Address" of "NET-
WORK. "
2 Enter the number by the ten-key display of the .
3 Setting is completed by tapping the .
SETTING THE KR-1W SUBNET MASK
The subnet mask of KR-1W can be set.
1 Tap the of the set item display "KR-1W Subnet Mask" of "NET-
WORK. "
2 Using the ten-key display of the , enter the same subnet mask as
that of the PC to be connected.
3 Setting is completed by tapping the .
SETTING THE KR-1W DEFAULT GATEWAY
The default gateway of KR-1W can be set.
1 Tap the of the set item display "KR-1W Default Gateway" of "NET-
WORK. "
2 Using the ten-key display of the , enter the same default gateway
as that of the PC to be connected.
3 Setting is completed by tapping the .
IMAGE FORMAT FOR SHARED FOLDER TRANSFER
This sets the image format transferred to the shared folder. The default setting is "Bitmap".
1 Tap the of the "Image format of shared folder transfer" in "Network
Settings".
2 Tap the and select either "Bitmap" or "JPEG"
3 Press to complete the setting.
DATA OUT button
Set Condition button
Setting Change butto
n
Set Condition button
Setting Change butto
n
OK button
Set Condition button
Setting Change butto
n
OK button
Set Condition button
Setting Change butto
n
OK button
Set Condition button
Setting Change butto
n
OK button