9
CAUTION
Important caution
The following patients need extra attention.
Patients with infectious disease such as Keratoconjunctivitis Epidemica
Ensuring the Safety of Patients and Operators
When operating the chinrest up/down button, be careful not to pinch the patient's hand. The patient may be
injured.
When operating the instrument, use much care so that operator's finger or hand is not pinched between the
reverse side of forehead rest, a measuring head and an intraocular pressure measurement window. Or the oper
-
ator may be injured.
To avoid injury to the operator, be careful not to get the finger or hand of the operator who is opening the eyelids
caught in the instrument.
Each time one patient is changed to another, replace the chinrest tissue with a new one.
To avoid injury to the operator, do not open or close the printer cover while the built-in printer is operating.
To avoid injury to the patient, be careful not to touch the patient when operating the control lever.
To avoid injury to the patient, be careful not to move the patient's face while the main body unit is in alignment
operation.
When moving the instrument, two people should lift from the bottom of the device. One person lifting the device
may cause harm to his back or injury by falling parts.
When holding the bottom of the instrument, avoid touching a projection of screws to prevent injury.
To prevent damage and injury, do not hold anything but bottom. If you hold, it may cause to catch the finger or to
damage the instrument by falling.
To prevent damage and injury, do not install the instrument on an uneven, unsteady or sloped surface.
To prevent injury, when setting an instrument on an instrument table, pay attention not to catch a finger between
the instrument and the table.
When installing the main body unit on an adjustable instrument table, etc., make sure that the chinrest does not
protrude from the top plate. When a load is applied to the chinrest, the instrument may tip over and cause injury.
Do not operate a touch panel during barcode data entering by barcode reader. If you enter data when tapping the
button on the touch panel, the barcode may not be read normally.
Do not align, measure, or output data during barcode data entering by barcode reader. If you enter data during
these operations, the barcode may not be read normally.
Take care not to enter the wrong patient information. It may be mistaken for information from another patient.
To avoid potential injury in case of malfunction, including a paper jam, be sure to shut off the power before
attempting to repair the built-in printer.
To avoid potential injury caused by the edges and metal parts of the built-in printer, do not touch the built-in
printer body while the printer is in operation or when replacing the printer paper.
Before measuring, check if there is any foreign matter on and around the measuring nozzle. If there is any, it may
enter and damage the patient's eye during the measurement.
To avoid injury when operating the instrument, be careful about the cover not to catch the fingers of the patient.
Tell this to the patient, too.
Before measuring, set the safety stopper to prevent the intraocular pressure measuring window from hitting the
patient's eye.
Set it respectively for the right and left eyes.
Set the safety stop from the side of the instrument.
Setting operations from other positions, it is not easy to check positions of the eye and intraocular pressure mea-
suring window, may cause injury by touching intraocular pressure measuring window to a patient.
To Next Page
Loading...
