Workman HDX AutoPage 4 − 58Drive Train
17.Slide rotary switch (Fig. 55 item 56) onto shift drum
shaft and align tab on switch with slot in sector gear cov-
er. Secure switch with spring washer, thrust washer and
snap ring.
18.Noting location of missing tooth, slide shift lever (item
39) onto shift shaft. Secure lever with lock nut. Torque
lock nut from 12 to 18 ft−lb (17 to 24 N−m).
19.If speed sensor (Fig. 55 item 55) was removed, apply
a light coating of multi−purpose lithium grease onto new
O−ring (Fig. 55 item 58) and install onto sensor. Slide
sensor into gear case bore and secure with button head
screw. Torque screw from 7 to 9 ft−lb (10 to 12 N−m).
To Next Page
Loading...
