Workman HDX Auto
Page 3 − 19
Kohler Gasoline Engine
Removal (Fig. 19)
1. Park vehicle on a level surface and engage parking
brake.
2. Raise or remove the cargo bed or other attach-
ment(s). If bed is raised, place safety support on lift cylin-
der.
3. Make sure that the engine is stopped and the key is
removed from ignition switch. Allow engine to cool.
4. To prevent contamination of engine lubrication sys-
tem during adapter removal, thoroughly clean exterior of
filter adapter, hoses and fittings.
5. Remove oil filter adapter components as needed us-
ing Figures 19 and 20 as guides.
Installation (Fig. 19)
1. Install removed oil filter adapter components using
Figures 19 and 20 as guides. If hydraulic fittings were re-
moved from oil filter adapter, apply thread sealant to
threads of fittings before installing them into adapter.
2. Check and adjust engine oil level.
3. Lower or install the cargo bed or other attachment(s).
Figure 20
1. Oil filter assembly
2. Hydraulic tube
3. Hydraulic tube
1
2
3
Gasoline Engine
Kohler
To Next Page
Loading...
