EasyManuals Logo

Toshiba B-FV4 Series User Manual

Toshiba B-FV4 Series
302 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #116 background imageLoading...
Page #116 background image
6. SYSTEM MODE EO18-33030
6.2 Parameter Clear
6-3
6.2 Parameter Clear
By resetting your printer, you can return your printer to the state it was in when you receive it. This can help
you solve some problems caused by settings changed during the printing.
1. Turn off the printer.
2. Press and hold the [FEED] Button while turning on the printer.
3. Both status lights (LED 1 and LED 2) will light up in the following order:
Orange Green Other colour sequences
4. Release the [FEED] button when both lights turn to red.
5. Press and hold the [FEED] button for 3 seconds and release it. Both status lights blink red three
times, and turn to solid orange for a few seconds.
6. The printer will restore to default setting and reset automatically.
NOTE: In step 5, if you do not hold the [FEED] button long enough, LED 2 will blink orange three
times while LED 1 goes out. It means your printer is not reset.
Parameter Initial Setting
Tone adjust value(Trans.) -3
Tone adjust value(Direct) 0
Feed adjust value 0.0 mm
Cut adjust value 0.0 mm
Backfeed adjust value 0.0 mm
X-coordinate adjust value Not clear
Codepage PC-850
Zero Font No slash
Euro Code 0xB0
Control Code Auto change Mode
Maxi Code Spec TYPE1 (Normally)
Label Pitch 76.2 mm
Effective print width 104.0 mm
Effective print length 74.2 mm
Print mode Continuity print
Print speed 203 dpi : 5 ips / 300 dpi : 4 ips
Print sensor select Transmissive sensor
Auto status response Disable
Ribbon detect sensor Not clear
Feed key Feed
Forward Feed Wait Enable
Auto Calibration Not clear
Auto TPH check Disable
PC save auto call mode Flash memory
Multiple Label Disable
BASIC Interpreter Disable
Reserved item 1 Not clear
Reserved item 2 Not clear
Destination Not clear

Table of Contents

Other manuals for Toshiba B-FV4 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toshiba B-FV4 Series and is the answer not in the manual?

Toshiba B-FV4 Series Specifications

General IconGeneral
Resolution203 dpi
Print MethodThermal Transfer / Direct Thermal
2D CodesData Matrix, PDF417, QR Code, Maxi Code
Operating Temperature5 – 40 °C
Storage Temperature-20 – 60 °C
Power Supply100-240 VAC, 50/60 Hz
InterfacesUSB, Serial (RS-232)
Media Width25.4 – 112 mm

Related product manuals