EasyManuals Logo

Toshiba B-FV4 Series User Manual

Toshiba B-FV4 Series
302 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #35 background imageLoading...
Page #35 background image
1. OUTLINE EO18-33030
1.6 Supply Specifications
1-23
1.6.2 Media Type (B-FV4D-GL)
The table below shows the size and shape of the media that can be used on this printer.
B-FV4D-GL Unit: mm (inch)
Issue mode
Item
Cut mode
Label width 102.0 (4.0)
Cut length 25.4 to 152.4 (1.0 to 6.0)
Thickness 0.06 to 0.19 (0.0024 to 0.0075)
Max. outer roll diameter
Ø127 (5.0)
Roll direction
Outside wound
Inner core diameter 40.0 (1.57)
NOTES:
1. To ensure print quality and print head life use only TOSHIBA TEC approved media.
2. A label jam is more likely to occur with the approach of label end because labels around the paper core
curl intensely.
1.6.3 Detection Area of the Feed Gap (Transmissive) Sensor
The Transmissive sensor is fixed and positioned at 6.35 mm (for GS/TS Type) or 6.27 mm (for GH Type)
right of the centre of the media path.
The Transmissive Sensor detects a gap between labels, as illustrated below.
Min. 2 mm
(Min. 6 mm:
cut mode)
Min. 8 mm
Sensor position
A
rea to be detected
Label
Gap
Label
Sensor position
Media feed direction
Print side
6.35 mm (for GS/TS Type)
6.27 mm (for GH Type)
Feed Direction
Cut position
Label without liner

Table of Contents

Other manuals for Toshiba B-FV4 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toshiba B-FV4 Series and is the answer not in the manual?

Toshiba B-FV4 Series Specifications

General IconGeneral
Resolution203 dpi
Print MethodThermal Transfer / Direct Thermal
2D CodesData Matrix, PDF417, QR Code, Maxi Code
Operating Temperature5 – 40 °C
Storage Temperature-20 – 60 °C
Power Supply100-240 VAC, 50/60 Hz
InterfacesUSB, Serial (RS-232)
Media Width25.4 – 112 mm

Related product manuals