EasyManuals Logo

Toshiba B-FV4 Series User Manual

Toshiba B-FV4 Series
302 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
2. ELECTRONICS SPECIFICATIONS EO18-33030
2.1 Main PC Board Diagram
2-2
Thermal Printhead (TPH)
It consists of a line of tiny resistors that is electronically controlled to produce heat for printing. For
direct thermal printing, a TPH directly heats up an area of the thermal paper to produce an image.
Stepping Motor
A stepping motor rotates certain degrees in each step in response to an electronic pulse.
RTC (Optional)
A real-time clock tracks the current date and time.
Cutter or Peeler * (Optional)
A cutter is a guillotine cutter which automatically cuts the printed label. There are two cutting types:
full and partial. A peeler automatically removes the liner from a printed label. The sensor on the
peeler detects if the peeled label is taken away.
* For B-FV4D-GH, the peeler is installed as standard.
* For B-FV4D-GL, the full-cut type cutter is installed as standard.

Table of Contents

Other manuals for Toshiba B-FV4 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Toshiba B-FV4 Series and is the answer not in the manual?

Toshiba B-FV4 Series Specifications

General IconGeneral
Resolution203 dpi
Print MethodThermal Transfer / Direct Thermal
2D CodesData Matrix, PDF417, QR Code, Maxi Code
Operating Temperature5 – 40 °C
Storage Temperature-20 – 60 °C
Power Supply100-240 VAC, 50/60 Hz
InterfacesUSB, Serial (RS-232)
Media Width25.4 – 112 mm

Related product manuals