Toshiba B-FV4 Series - Replacing the Ribbon Sensor

3. REPLACING THE IMPORTANT PARTS EO18-33030
3.1 Replacing the Parts for B-FV4T-GS/TS
3-12
3.1.5 Replacing the Ribbon Sensor
1. Refer to Section 3.1.2 to remove the printer module.
2. Use a Phillips screwdriver to remove the 1 screw from the Ribbon Sensor on the left side of the printer
module.
3. Take off the ribbon sensor.
4. Replace the ribbon sensor with a new one and then reassemble it in the reverse order of removal.
5. After replacing, make sure the printer is performing correctly regarding the following points.
 Printing is performed correctly and the ribbon is not slack or wrinkled.
 When the ribbon is unloaded and thermal transfer printing is performed, an error occurs.
(The ribbon sensor detects the status correctly.)
Screw
Ribbon Sensor