7. B-FV Setting Tool EO18-33030
7.4 Working with B-FV Setting Tool (V1.0.27)
7-62
5. After your printer restarts, click Get to get the IPv4 information of your printer. If you are using a
static IP address, you’ll get the same settings as it is in the previous step; if you are using DHCP,
the DHCP server will automatically populate the IP Address, Subnet Mask and Gateway boxes
under Current IPv4.
6. In the Input/Output Port list, click LAN, and click Setting.
7. In the Setting LAN dialog box, do one of the following to configure your IP address:
∙ If you are using a static IP address, in the IP Address
box, enter the IP address under IPv4 in the WLAN tab
and click OK.
∙ If you are using a dynamic IP address provided by
DHCP, in the IP Address box, enter the IP address
under Current IPv4 in the WLAN tab and click OK.
Changing the Region Setting
Follow the steps below to change the Region setting after setting up a wireless connection .
1. In the Input/Output Port list, click the preferred interface.
Note Selecting USB is recommended. LPT is not available.
To Next Page
Loading...
Need help?
General
