Toshiba B-FV4 Series User Manual

7. B-FV Setting Tool EO18-33030
7.4 Working with B-FV Setting Tool (V1.0.27)
7-61
∙ If you’re using WPA-Personal or WPA2 Personal, enter your password in the WPA Pre-shared
Key box.
∙ If you’re using 802.1X, WPA-Enterprise or WPA2 Enterprise, choose your EAP authentication
method in the EAP Method list, and enter your username and password in EAP User Name and
EAP Password boxes respectively. If you’re using TTLS mode, you can choose the TTLS
encryption method from the TTLS Method list.
4. Do one of the following to configure your IPv4 settings:
∙ If you have a static IP address, fill the IP Address, Subnet Mask and Gateway box under IPv4
according to your network settings, make sure DHCP is disabled, then click Send.
∙ If you don’t have a static IP address, make sure DHCP is enabled and click Send.

Toshiba B-FV4 Series Specifications

General

Resolution	203 dpi
Print Method	Thermal Transfer / Direct Thermal
2D Codes	Data Matrix, PDF417, QR Code, Maxi Code
Operating Temperature	5 – 40 °C
Storage Temperature	-20 – 60 °C
Power Supply	100-240 VAC, 50/60 Hz
Interfaces	USB, Serial (RS-232)
Media Width	25.4 – 112 mm