6. SYSTEM MODE EO18-33030
6.5 Self-Test Printing / Dump Mode
6-10
11. Tone Adjust (T)
The print darkness in thermal transfer mode
For B-FV4D, it is disabled.
12. Tone Adjust (D)
The print darkness in direct thermal mode
The positive number makes the printout darker, and the negative number makes the printout lighter. The
range is -10 ~ +10. The default value is 00.
13. Feed Adjust
Move the existing feed position forward or backward. The range is -50.0 ~ +50.0, and the value is
adjustable in increments of ± 0.1 mm.
14. Cut Adjust
Move the existing cutting line or the peeling position forward or backward. The range is -18.0 ~ +18.0,
and the value is adjustable in increments of ± 0.1 mm.
15. Backfeed Adjust
Your printer moves the paper forward in a predefined length 1 second after printing, and pulls the paper
back in a predefined length once the printing begins again. The range is -9.9 ~ +9.9, and the value is
adjustable in increments of ± 0.1 mm.
16. X Coordinate Adjust
Move the print position horizontally. The positive number is right, and the negative number is left. The
range is -99.5 ~ +99.5, and the value is adjustable in increments of ± 0.5 mm.
17. Codepage
A code page is a character set table used to map the characters input from the keyboard.
18. Zero Slash
Display a zero with or without a slash through it.
19. Feed Key
It defines the action of the FEED button. When it is set to Feed, your printer feeds a blank label each
time the button is pressed; when it is set to Print, your printer reprints the last label each time the button
is pressed.
20. Euro Code
The hexadecimal code of the euro sign (€) in the code page
21. Control Code
The control code used by Toshiba Printer Control Language (TPCL)
22. Maxi Code Spec
It can be set to TYPE 1 or TYPE 2. TYPE 1 is the standard type and TYPE 2 is the custom type.
23. Sensor Select
The media sensor you select. The default sensor is transmissive.
24. Print Speed
The speed of printing
The unit is inch per second (ips). For 200 dpi, the default speed is 5 ips; for 300 dpi, the default speed is
To Next Page
Loading...
Need help?
General
