6. SYSTEM MODE EO18-33030
6.5 Self-Test Printing / Dump Mode
6-12
39. Bit
The length of the data transmitted.
40. Stop Bit
The stop bit is at the end of a string of data bits. It is used in asynchronous transmission to let the
receiver know that the string of data bits being transmitted is end.
41. Parity
A parity bit is added to a string of data bits to check if the data is correct. There are two parity check
modes: Odd and Even. If it is set to None, no parity check is used.
42. Flow
It controls the data flow between the computer and your printer.
43. IP Address
The static IP address of your printer
The default value is “192.168.010.020.”
44. Subnet Mask
The manually specified subnet mask of your printer
The default value is “255.255.255.000.”
45. Gateway
The manually specified gateway of your printer
The default value is “000.000.000.000.”
46. MAC Address
The unique address assigned to your printer that connects to the internet.
47. DHCP
When DHCP is enabled, it assigns an IP address to your printer automatically. The default setting is
OFF.
48. DHCP Client ID
It is an arbitrary value sent to the DHCP server to reserve an IP address for your printer.
49. DHCP Host Name
The name of a DHCP client
If you have specified a host name, it will show here.
50. Socket Communication
When it is enabled, the host communicates with your printer via the socket. The default setting is ON.
51. Socket Port
The socket number of your printer
52. WLAN IP Address
When the Wireless LAN interface option is installed, this item will appear showing the static IP address
of your printer.
The default value is “000.000.000.000.”
To Next Page
Loading...
Need help?
General
