Station
ISDN
Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04 5-39
Station
08 LCR Group Select the LCR Group number to which this BRI Station belongs.
Possible values: 1~16 (default = 1)
10 Speech Capability Enable speech capability. See Table 5-5 on page 40.
Possible values: Enable (default) or Disable
11 3.1 KHz Audio Enable 3.1 KHz audio capability. See Table 5-5 on page 40.
Possible values: Enable (default) or Disable
12 7 KHz Audio Enable 7 KHz audio capability. See Table 5-5 on page 40.
Possible values: Enable or Disable (default)
13 64Kbps
Unrestricted
Enable one of the unrestricted capabilities. See Table 5-5 on page 40.
Possible values: Enable (default) or Disable
14 56Kbps
Unrestricted
15 2 x 64Kbps
Unrestricted
16 B Channel
Selection
Select originating B Channel method.
Possible values:
• Exclusive – (default) Channel is indicated, and no alternative is acceptable.
• Preferred – Channel is indicated, and any alternative is acceptable.
• Any Channel – Channel is indicated, and any channel is acceptable.
17 Idle B Channel
Selection
Choose Idle B Channel selection method.
Possible values: Forward Cyclic, Backward Cyclic, Forward Terminal or Backward
Terminal (default)
• Select Forward Cyclic (from lowest to highest number of B-channel).
• Select Backward Cyclic (from highest to lowest number of B-channel).
• Select Forward Terminal for the lowest number B-channel (The Low-Low B-channel
selection).
• Select Backward Terminal for the highest number B-channel. (The High-High B-
channel selection)
18 Interdigit Timer 1 Select the Interdigit timer value, to time-out during dial tone.
Possible values: 1~180 (default = 15)
19 Interdigit Timer 2 Interdigit timer value to time-out after the first digit is dialed.
Possible values: 1~180 (default = 5)
20 CESID Enter the CESID value for 911 calls.
Possible values: Up to 16 ASCII characters (default = no value)
21 Number Voice Calls
Allowed
Select the Number of Voice Calls Allowed. If a selection is not made, previously written
data in this field is erased.
Possible values: One or Two (default)
Note If One is selected, the other channel is reserved for Data.
22 Service Tone
Permission
Enable Service Tone Permission. Select Disable for modems and faxes.
Possible values: Enable or Disable (default)
FIELD DESCRIPTION
To Next Page
Loading...
