Trunks
Trunk DID/DNIS Setup Wizard
6-36 Strata CTX Programming - Part 2: CTX WinAdmin Programming 6/04
4. If you clicked Create in Step 3, the Create New
DID/DNIS ILG screen displays (shown at right).
Fill in the three fields on the screen and click Create Now. The
DID/DNIS Number Range Wizard screen displays with the
new information.
5. (Optional) Click DID/DNIS Table View to view existing DID/
DNIS assignments. This table displays assignments for all
DID/DNIS ILGs currently programmed in the CTX. For more
details, see “DID/DNIS Table View” on page 6-21.
6. After creating or selecting a DID/DNIS ILG, click Next.
Step 2: Create or Delete DID/DNIS Numbers for ILG 2
1. From the Step 2: 309 Create or Delete DID/DNIS
Numbers for ILG 2 screen (shown right), click
Create to create a block of DID/DNIS numbers.
The numbers are created in consecutive order.
The Create DID/DNIS Numbers screen displays (shown
right).
• Specify the first number in the DID/DNIS block.
Note The quantity of digits must match the quantity of digits
assigned to the selected ILG (refer back to “DID/DNIS
Digit Length” on the previous screen).
• Specify the DID/DNIS Number block size that should be
created. This is the quantity of DID/DNIS numbers
ordered from the DID/DNIS provider.
• Specify “overwrite existing” or “add to existing” DID/
DNIS numbers. If no DID/DNIS numbers exist, add or
overwrite is OK.
...or click Delete and the delete DID/DNIS number dialog box
displays (shown right). Specify the first and last DID/DNIS
number to delete using the drop-down boxes; or, check mark
Delete all DID/DNIS numbers. Click Delete Now. The
numbers are deleted.
CAUTION! Overwrite erases all existing DID/DNIS numbers currently programmed for the
selected ILG.
To Next Page
Loading...
