Strata CTX Programming Guidelines
Step 1: Use Default Auto-programming to Start Up
1-6 Strata CTX Programming - Part 1: Getting Started 6/04
Table 1-7 IPT Automatic Settings
Table 1-8 System Related Basic Settings
BIPU-Q1A Initial Programming
After initializing the CTX System with BIPU for Strata Net over IP, Strata CTX detects the BIPU card for
Strata Net over IP and basic programming is set automatically.
Table 1-9 BIPU-Q1A Automatic Settings
Item Description Settings
DN Setting
DN setting of the terminal
accommodated in BIPU
The number plan conforms to BDKU16.
Assigned in the order of the lowest slot
number.
Accommodated terminal setting
(Station ID)
Parameter setting of Station
ID in BIPU
Station ID = PDN
Accommodated terminal setting
(IP Address)
Parameter setting of IP
address in BIPU
IP address = 0.0.0.0
Accommodated terminal setting
(MAC addresses)
Parameter setting of MAC
addresses in BIPU
MAC addresses = (no data)
Item Description Settings
QOS Control
Setting of priority control by
Diffserv/IEEE802.1p
Use of Diffserv: Not applicable
Set value of DSField = 0
Use of IEEE802.1p: Not applicable
Priority level: Voice
Station ID
Automatic setting of Station
ID
Not allowed
Terminal authentication setting
Application or non application
of connection restriction
function using MAC address
Not apply
Item Description Settings
Card Type Card Type BIPU-Q1A
IP Address (BIPU) IP address of BIPU-Q1A
In the order of smallest number of the slot
where BIPU is inserted
192.168.254.800 for 1st BIPU
.801 for 2nd BIPU
.802 for 3rd BIPU
Private address will be set.
Subnet mask (BIPU) Subnet mask of BIPU-Q1A 255.255.255.0
Default gateway Default gateway of BIPU-Q1A 0.0.0.0
To Next Page
Loading...
