Telephone Button Programming
100 Series Programs
Strata CTX Programming - Part 3: Telephone Button Programming 6/04 13-27
Telephone Button
Programming
120
Tenant Data
Assignment
,
+ROG
This program enables you to select an Attendant or Night Bell to ring
when dialing 0 in Day 1, Day 2 or Day 3 mode for up to eight different
Tenants. You can also assign the general purpose relay to the Night
Bell in this program.
120-00 Tenant Number
n,
+ROG
,
n = 1~8. No Data (Default) Select the Tenant number for which the daily schedules will be
configured.
120-01,
120-02,
120-03
Dial 0 Call Day 1, 2, or
3 Dst Type
)%
, n=1 or 3,
+ROG
or (see next row)
n = 1. No Data (default)
2. Dialing Digits (see
”n=2” below)
3. Night Bell
Select to call an Attendant or select to ring the Night Bell when dialing
the Tenant Attendant Access Code in the Day1, Day 2, or Day 3
mode for this Tenant.
The Tenant Attendant Access Code must be assigned in Prg 102. If it
should be “0,” the Attendant Console Group Access Code, which is
“0,” must be deleted.
)%
, n=
(Dialing
Digits),
6SNU
.
DEST=enter values.
+ROG
DEST
=
Up to 32 digits for each
Day Mode selected
(default = noData)
Enter the PDN of the Attendant (BATI) to ring when dialing Tenant
Attendant Access Code in Day, Day2, or Day 3 mode.
120-04 Night Mode Relay
)%
, n,
+ROG
n = BIOU 1 = relay 1~4
BIOU 2 = relays 5~8
ACTU = relay 5
Enter the General Purpose relay number assigned to the Night Bell.
BIOU relays 1~8. This operation activates the relay continuously
when the system is in the night mode.
120-05 Night Bell Relay
)%
, n,
+ROG
n = BIOU 1 = relay 1~4
BIOU 2 = relays 5~8
ACTU = relay 5
Enter the General Purpose relay number assigned to the Night Bell.
BIOU relays 1~8. This operation activates the relay when a CO line or
DID rings when the system is in night mode. The CO or DID line must
be assigned to ring the night bell.
Table 13-13 Program 117
Button Sequence Value(s) Summary
To Next Page
Loading...
