Telephone Button Programming
200 Series Programs
13-34 Strata CTX Programming - Part 3: Telephone Button Programming 6/04
Table 13-15 BRI Bearer Capability of ISDN
Bearer Services
Bellcore
Nat’l ISDN
ETSI TTC
Circuit Mode
Speech X X X
3.1kHz Audio X X X
7kHz Audio X X
Unrestricted Digital Information
64 kbps X X X
Rate adaptation
from 56 kbps
X
2x64 X X
Table 13-16 Programs 203~204
Button Sequence Value(s) Summary
203
Change DN
,
+ROG
This command changes DN.
203-00 Primary DN
n,
+ROG
n = Up to 5 digits Enter DN to change.
203-01 Enter new DN
)%
, n1,
+ROG
,
+ROG
n1 = Up to 5 digits Enter new DN.
204
DKT Parameters
,
+ROG
This command assigns DKT digital telephone data.
204-00 Primary DN
n,
+ROG
n = Up to 5 digits Primary DN
204-01 Station Type
)%
, n,
+ROG
n = 1. Extension
2. Attendant
For CTX R1 this must be set to “Extension.” The “Attendant” option is
not available for this release.
204-02 Key Strip Pattern
)%
, n,
+ROG
n = 1. Pattern1
2. Pattern2
3. Pattern3
4. None
Default key strip patterns for digital telephones. The selected Pattern
is applied to the “Key Strip Type” parameter (DKT3014 uses only
Pattern 1 or None).
• None - applies PDN to button 01 and blank to all other buttons.
• Pattern 1 - applies PDN to button 01, plus line buttons and DND.
• Pattern 2 - applies PDN to button 01, plus line buttons, One-
Touch buttons and DND.
• Pattern 3 - applies PDN to button 01 and blank to all other
buttons.
204-03 Key Strip Type
)%
, n,
+ROG
n = 1~24 Apply 1, 3, 10, 14, or 20 button keystrip type to digital telephones.
• 1 and 3 button keystrips apply to DKT2001 and DKT3001.
• 10 button keystrips apply to DKT2010 and DKT3010.
• 14 button keystrips apply to the Large LCD DKT3014
• 20 button keystrips apply to DKT2020 and DKT3020.
204-04 Add on Modules
)%
, n,
+ROG
n = 1. None
2. One Unit
3. Two Units
The Number of Add-on Modules assigned to this station.
204-05 Tone 1st /Voice 1st
)%
, n,
+ROG
n = 1. Tone
2. Voice
Set PDN to have Tone First or Voice First signaling when called.
For each iES32 PDN, set to “Tone First”, if set to Voice First iES32 will
not answer.
204-06 OCA Type
)%
, n,
+ROG
n = 1. Handset
2. Speaker
Select the OCA type. This field must be programmed with Auto OCA
Originate below.
To Next Page
Loading...
