Telephone Button Programming
300 Series Programs
13-64 Strata CTX Programming - Part 3: Telephone Button Programming 6/04
312-01
DID Number n = up to seven digits DID Number to be deleted.
313
Caller ID Assignment
,
+ROG
This program assigns Caller ID circuits to the CO Line to which the
circuit is connected. The ANI, DNIS, DID formats for TI and analog
DID CO Lines are also defined.
313-00 Trunk Number
n,
+ROG
,
n = 1~64 (CTX100)
1~96 (CTX670 Basic)
1~264 (CTX670 Exp.)
Enter the Trunk Number.
313-01 Signalling Method
)%
, n,
+ROG
n = 1. None (default)
2. ANI/DNIS-MCI
3. ANI/DNIS-Sprint
4. CLASS (Caller ID)
Specify the format for the interface being used.
313-02 Signalling Contents
)%
, n,
+ROG
n = 1. ANI and DNIS (default)
2. ANI only
3. DNIS only
4. DID only
Specify the contents of the ANI/DNIS format.
313-03 CLASS Equipment
Position
)%
, xxyyzz,
+ROG
xx = Cabinet 01 (CTX100),
01~02 (CTX670 Basic),
01~07 (CTX670 Exp.)
If the CLASS type is chosen, the trunk must be assigned to a Caller
ID circuit. Enter the RCIU/RCIS equipment number as xxyyzz.
Notes
• CLASS equipment numbers are required when assigning a trunk
to a RCIU/RCIS circuit.
• It can also be used to display the equipment location of existing
caller ID circuit to trunk assignments. Example: If the trunk should
be connected to a caller ID circuit (RCIU/RCIS) in cabinet shelf 5,
slot 2, circuit 3, enter 050203.
yy = Slot 01~8 (CTX100),
01~10 (CTX670)
zz = Circuit 01~08
315
T1 Trunk Card
,
+ROG
This command assigns T1 Trunk Card Data to the system.
315-00 T1 Equipment
Location
xxyy,
+ROG
xxyy xx = Cabinet 01,
yy = slot 01, 03, 05, or 07
Enter the RDTU PCB equipment location as xxyy:
Example: If the RDTU is installed in cabinet shelf 5, slot 3, enter
0503.
Cabinet numbers:
CTX100: Select 01 for Base and Expansion cabinet.
CTX670: Select 01 for Base and 02~07 respectively for each
Expansion cabinet.
Slot numbers:
CTX100: Select 01~04 for Base slots and 05~08 for Expansion slots.
CTX670: Select 01~08 for Base slots and 01~10 for Expansion slots.
...or xx = Cabinet 02~07,
yy = slot 01, 03, or 05
315-01 Coding Format
)%
, n,
+ROG
n = 1. None
2. PZC
3. B8ZS (default)
4. ZCS
Select the Coding Format.
315-02 Frame Format
)%
, n,
+ROG
n = 1. None
2. SF mode
3. ESF mode (default)
Select the Frame Format.
315-03 Time Slots n = 1. None
2. 8 Time Slots (default)
3. 16 Time Slots
4. 24 Time Slots
Set the number of Time Slots to be used.
Table 13-28 Programs 303~315 (continued)
Button Sequence Value(s) Summary
To Next Page
Loading...
