Applications, Tips and Tricks
IPT1020-SD Telephone Network Settings
Strata CTX Programming - Part 4: Appendices 6/04 A-9
Applications, Tips and
Tricks
IP Telephone Start Up Sequence
After the IP telephone network setting has been programmed, the following displays occur after the IP
telephone is hung-up:
Action LCD Indication Remarks
1. IPT
initializes.
2. IPT
searches
for IP
address.
Possible errors:
• IP address is
not set.
• No DHCP
server, etc.
If error occurs, IP address setting is carried out
continuously.
3. IPT
searches
for BIPU.
Retries every 10 seconds.
Possible errors:
• BIPU is not
found “time
out.”
• BIPU is not
found (Station
ID automatic
setting).
• BIPU is not
found
(StationID
manual setting)
• Multicast
address is
not
registered (BIPU IP address setting mode is
automatic setting by multicast)
• BIPU IP
address is not
registered
(BIPU IP address setting mode is manual
setting.
4. Registering
to BIPU
When registering fails, IPT retries by starting at
Step 2 again.
Error message:
“Exxx” is error
number.
5. Registering
completion
- normal
action.
LCD data is indicated from
CTX. Example:
IPADDRESS SETTING...
CAN’T SET IPADDRESS
SEARCHING BIPU
BIPU NOT FOUND
SEARCHING BIPU
CAN’T GET STATIONID
SEARCHING BIPU
STATION ID UNMATCH
NOT EXIST MULTICAST ADDR
NOT EXIST BIPU ADDRESS
REGISTERING IPT...
CAN’T REGISTER IPT:EXXX
To Next Page
Loading...
