TP-Link JetStream L2 User Manual

122
Link Monitoring: Displays whether the local client supports link monitoring function.
Variable Request: Displays whether the local client supports variable request
. If
supports, the local client can send some variable requests to the
remote client to learn about the link status from the response of
the remote client.
PDU Revision: Displays the Information TLV revision of Information OAMPDU.
Operation Status: Displays the operating status of the OAM connection.
 Disable: OAM is disabled on this port.

LinkFault: The link has detected a fault and is transmitting
OAMPDUs with a link fault indication.

PassiveWait: The port is in passive mode and is waiting to
see if the peer device is OAM capable.

ActiveSendLocal: The port is in active mode and is sending
local information.

SendLocalAndRemote: The local port has discovered the
peer but has not yet accepted or rejected the configuration of
the peer.
 SendLocalAndRemoteOK: T
he local device agrees the OAM
peer entity.

PeeringLocallyRejected: The local OAM entity rejects the
remote peer OAM entity.
 PeeringRemotelyRejected: The remote OAM entity reject
s the
local device.

NonOperHalfDuplex: Since Ethernet OAM functions are not
designed to work completely over half-
duplex ports. This
value indicates Ethernet OAM is enabled but the port is in
half-duplex operation.
Loopback Status: Displays the loopback status.

No Loopback: Neither the local client nor the remote client is
in the loopback mode.
 Local Loopback: The local client is in the loopback mode.

Remote Loopback: The remote client is in the loopback mode.

Remote Client
The local client part shows the information of the remote OAM entity.
Mode: Displays the OAM mode of the remote client.
Mac Address: Displays the MAC address of the remote client.
Vendor(OUI): Displays the vender’s OUI of the remote client.
An OUI address is a unique identifier assigned by IEEE to a
device vendor.
Max OAMPDU: Displays the maximum size of the OAMPDU.
Remote Loopback:
Displays whether the remote client supports remote loopback
function.
Unidirection: Displays whether the remote client supports unidirectional OAM
operation.
Link Monitoring: Displays whether the remote client supports link mon
itoring
function.

TP-Link JetStream L2 Specifications

General

Brand	TP-Link
Model	JetStream L2
Category	Switch
Language	English