EasyManua.ls Logo

TP-Link JetStream L2 - Tracert

TP-Link JetStream L2
316 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
299
17.4.2 Tracert
Tracert test function is used to test the connectivity of the gateways during its journey from the
source to destination of the test data. When malfunctions occur to the network, you can locate
trouble spot of the network with this tracert test.
Choose the menu MaintenanceNetwork DiagnosticsTracert to load the following page.
Figure 17-9 Tracert
The following entries are displayed on this screen:
Tracert Config
Destination IP:
Enter the IP address of the destination device.
Both IPv4 and IPv6 are
supported.
Max Hop:
Specify the maximum number of the route hops the tes
t data can pass
through.
Tracert Result
Here you can view the Tracert result.
Return to CONTENTS

Table of Contents

Other manuals for TP-Link JetStream L2

Related product manuals