298
4. If the port is 100Mbps and its connection status is normal, cable test can’t get the length of the
cable.
17.4 Network Diagnostics
This switch provides Ping test and Tracert test functions for network diagnostics.
17.4.1 Ping
Ping test function, testing the connectivity between the switch and one node of the network,
facilitates you to test the network connectivity and reachability of the host so as to locate the
network malfunctions.
Choose the menu Maintenance→Network Diagnostics→Ping to load the following page.
Figure 17-8 Ping
The following entries are displayed on this screen:
Ping Config
Enter the IP address of the destination node for Ping test.
and IPv6 are supported.
Enter the amount of times to send test data during Ping testing. The
default value is recommended.
Enter the size of the sending data during Ping testing. The default
value is recommended.
l:
Specify the interval to send ICMP request packets. The default value
is recommended.
Ping Result
Here you can view the Ping result.
To Next Page
Loading...
Need help?
General