TP-Link JetStream L2 User Manual

263
15.1.2 Port Config
On this page you can configure all ports' LLDP parameters.
Choose the menu LLDP→Basic Config→Port Config to load the following page.
Figure 15-2 Port Configuration
The following entries are displayed on this screen:

LLDP Port Config
Port Select: Select the desired port to configure.
Admin Status: Select the port’s LLDP operating mode:
 Tx&Rx: Send and receive LLDP frames.
 Rx_Only: Only receive LLDP frames.
 Tx_Only: Only send LLDP frames.
 Disable: Neither send nor receive LLDP frames.
Notification Mode: Enable/Disable the ports' SNMP notification.
If enabled, the local
device will notify the trap event to SNMP server.
Included TLVs: Select TLVs to be included in outgoing LLDPDU.
Details: Click Details to display the included TLVs.
15.2 Device Info
You can view the LLDP information of the local device and its neighbors on the Local Info and
Neighbor Info pages respectively.
15.2.1 Local Info
On this page you can see all ports' configuration and system information.

TP-Link JetStream L2 Specifications

General

Brand	TP-Link
Model	JetStream L2
Category	Switch
Language	English