166
Figure 10-18 Static Multicast
The following entries are displayed on this screen:
Static Multicast Config
VLAN ID: Enter the VLAN ID.
Multicast IP: Enter the multicast IP address.
Member Ports: Enter the member ports of the static multicast group.
Static Multicast List
Select: Select the static multicast group you want to change.
VLAN ID: Displays the VLAN ID.
Multicast IP: Displays the multicast group IP address.
Member Ports:
Displays the member ports of the static multicast
group.
10.2.6 Querier Config
In an IPv6 multicast network that runs MLD, a Layer 3 multicast device works as an MLD querier to
send out MLD queries and manage the multicast table. But MLD is not supported by the devices in
Layer 2 network. MLD Snooping Querier can act as an MLD Router in Layer 2 network. It can help
to create and maintain multicast forwarding table on the switch with the Query messages it
generates.
Choose the menu Multicast→MLD Snooping→Querier Config to load the following page.
Figure 10-19 Querier Config
To Next Page
Loading...
Need help?
General