EasyManua.ls Logo

TP-Link JetStream L2 - NTDP Config

TP-Link JetStream L2
316 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
282
16.2.3 NTDP Config
On this page you can configure NTDP globally.
Choose the menu ClusterNTDPNTDP Config to load the following page.
Figure 16-8 NTDP Config
The following entries are displayed on this screen:
Global Config
NTDP: Enable/Disable NTDP for the switch globally.
NTDP Interval Time: En
ter the interval to collect topology information. The default is 1
minute.
NTDP Hops:
Enter the hop count the switch topology collects. The default is 3
hops.
NTDP Hop Delay:
Enter the time between the switch receiving NTDP request
packets and the switch
forwarding NTDP request packets for the
first time. The default is 200 milliseconds.
NTDP Port Delay:
Enter the time between the port forwarding NTDP request packets
and its adjacent port forwarding NTDP request packets over. The
default is 20 milliseconds.

Table of Contents

Other manuals for TP-Link JetStream L2

Related product manuals