249
14.2 Notification
With the Notification function enabled, the switch can initiatively report to the management station
about the important events that occur on the Views (e.g., the managed device is rebooted), which
allows the management station to monitor and process the events in time.
The notification information includes the following two types:
Trap ： Trap is the information that the managed device initiatively sends to the Network
management station without request.
Inform：Inform packet is sent to inform the management station and ask for the reply. The switch
will resend the inform request if it doesn’t get the response from the management station during
the Timeout interval, and it will terminate resending the inform request if the resending times reach
the specified Retry times. The Inform type, employed on SNMPv2c and SNMPv3, has a higher
security than the Trap type.
14.2.1 Notification Config
On this page, you can configure the notification function of SNMP.
Choose the menu SNMP→Notification→Notification Config to load the following page.
Figure 14-8 Notification Config
The following entries are displayed on this screen:
Create Notification
Select the IP mode.
Enter the IP Address of the management Host.
Enter the number of the UDP port used to send notifications.
The UDP port functions with the IP address for the notification
sending. The default is 162.
Enter the User name of the management station.
Select the Security Model of the management station.
To Next Page
Loading...
Need help?
General