EasyManua.ls Logo

TP-Link JetStream L2 - TACACS+ Server Config

TP-Link JetStream L2
316 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
232
View, edit and delete the configured RADIUS servers in the Server list.
Entry Description:
Server IP:
Enter the IP of the server running the RADIUS secure protocol.
Shared Key:
Enter the shared key between the RADIUS server and the switch.
The RADIUS server and the switch use the key string to encrypt
passwords and exchange responses.
Auth Port:
Specify the UDP destination port on the RADIUS server for
authentication requests.
Acct Port:
Specify the UDP destination port on the RADIUS server for
accounting requests.
Retransmit:
Specify the number of times a request is resent to a server if the
server does not respond.
Timeout:
Specify the time interval that the switch waits for the server to reply
before resending.
13.7.4 TACACS+ Server Config
This page is used to configure the authentication servers running the TACACS+ security protocols.
Choose the menu Network SecurityAAATACACS+ Conifg to load the following page.
Figure 13-4 TACACS+ Server Config
Configuration Procedure:
Configure the TACACS+ server’s IP and other relevant parameters under the Server Config.
View, edit and delete the configured TACACS+ servers in the Server list.
Entry Description:
Server IP:
Enter the IP of the server running the TACACS+ secure protocol.
Shared Key:
Enter the shared key between the TACACS+ server and the switch.
The TACACS+ server and the switch use the key string to encrypt
passwords and exchange responses.
Timeout:
Specify the time interval that the switch waits for the server to reply
before resending.

Table of Contents

Other manuals for TP-Link JetStream L2

Related product manuals