TP-Link JetStream L2

To Next Page

To Previous Page

180

Figure 11-11 Storm Control

The following entries are displayed on this screen:

 Storm Control Config

Port Select: Click the Select button to quick-

select the corresponding port

based on the port number you entered.

Select:

Select the desired port for Storm Control configuration. It is

multi-optional.

Port: Displays the port number of the switch.

Broadcast Rate

(bps):

Select the bandwidth for receiving broadcast packets on the port.

The

packet traffic exceeding the bandwidth will be discarded.

Select Disable to disable the storm control function for the port.

Multi

cast Rate

(bps):

Select the bandwidth for receiving multicast packets on the port.

The packet traffic exceeding the bandwidt

h will be discarded.

Select Disable to disable the storm control function for the port.

UL-Frame

Rate

(bps):

Select the bandwidth for receiving UL-

Frame on the port. The

packet traffic exceeding the bandwidth will be discarded. Select

Disable to disable the storm control function for the port.

LAG: Displays the LAG number which the port belongs to.

Note:

If you enable storm control feature for the ingress rate limit-enabled port, ingress rate limit feature

will be disabled for this port.

TP-Link JetStream L2 - Page 190