TP-Link JetStream L2 - Page 207

197
Figure 12-11 Action Create
The following entries are displayed on this screen:

Create Action
Select Policy: Select the name of the policy.
Select ACL: Select the ACL for configuration in the policy.
S-Mirror: Select S-
Mirror to mirror the data packets in the policy to the specific
port.
S-Condition: Select S-Condition to limit the transmission
rate of the data packets in
the policy.
 Rate:
Specify the forwarding rate of the data packets those match
the corresponding ACL.
 Out of Band:
Specify the disposal way of the data packets those
are transmitted beyond the rate.
Redirect: Select Redirect to
change the forwarding direction of the data packets
in the policy.
 Destination Port:
Forward the data packets those match the
corresponding ACL to the specific port.
 VLAN ID:
Forward the data packets those match the
corresponding ACL in the corresponding VLAN.
QoS Remark:
Select QoS Remark to forward the data packets based on the QoS
settings.
 DSCP:
Specify the DSCP region for the data packets those match
the corresponding ACL.
 Local Priority:
Specify the local priority for the data packets those
match the corresponding ACL.