Valleylab CUSA EXcel-8 - Page 158

V
Suction Control Valve
5. Remove the suction control valve from the manifold bracket:
a. Remove three screws (M4 socket head cap screws) from the suction
control valve.
Note: A lock washer secures the screw on each end of the assembly,
but no lock washer secures the third screw.
b. Lift the suction control valve from the manifold bracket.
Note: The inlet screen for the suction control valve becomes
unattached when you lift the suction contro] valve off the manifold
bracket.
Figure 11-18.
Removing the suction control valve
from the manifold bracket
Suction control
valve
Manifold bracket Inlet screen
11-26 CUSA EXcel-8 System Service Manual