Quality of the Video is Bad
Symptom: The video quality from the device is bad
Action:
Verify the cable between the camera and the device. Try another cable to see if video quality
improves.
Web status should be checked for lock / unlock status
From the Web Interface video tab, verify the values for resolution, bit rate and frame rate are
supported by the camera.
If available, try another camera to see if video quality improves.
Ping the device to check for network latency.
From the Web Interface, go to the Clip Retrieval page and verify if the quality of the video.Try
the same from other workstations on other locations within the same network.
Check the internal temperature of the device from the Home on the web interface to see if the
device is overheating.
Troubleshooting
111
www.verint.com/video_solutions
To Next Page
Loading...
Need help?
General
