Single H.264:A single high-performance H.264 stream and a single MPEG-4 stream per
video input.
Single H.264 (Legacy):A single high-performance H.264 stream and a single MPEG-4
stream per video input.
Dual H.264:Two H.264 streams with lower resolution and framerate and a single MPEG-4
stream per video input.
6. Click Reboot Unit for the change to take effect.
7. Click OK to close the Unit Configuration dialog box.
8. Click Exit.
CAUTION: Once you have added the S1816e--SP or S1816e-SR to Nextiva Control Center,
changing the mode requires that you delete the device from Nextiva Control Center and
then use SConfigurator to change the mode; you will be required to add the device again
in Nextiva Control Center.
Setting the Video Standard
The S1800e series device can run in one of two video standards (NTSC or PAL) and you can use
different standards when deploying the devices across multiple sites. The two video standards
settings are:
National Television Standards Committee (NTSC) is the standard that is used in most of the
Americas, a number of South American countries, and some Asian countries, including Japan.
NTSC uses the format of 525 picture lines and a 60Hz lighting frequency.
Phase Alternation by Line (PAL) is the standard in the United Kingdom, much of Western Europe,
several South American countries, some Middle East and Asian countries, several African countries,
Australia, New Zealand, and other Pacific island countries. PAL uses the format of 625 picture lines
and a 50Hz lighting frequency.
CAUTION: You should change the video profile settings using a video management software.
► Perform the following steps:
1. Start SConfigurator.
2. Select the Units tab, then click Discover.
3. Select the Nextiva device, and click Configure.
4. In the tree view, click Unit >Video.
Chapter 4: Using SConfigurator for Configuration
Verint Video Intelligence Solutions
62
To Next Page
Loading...
Need help?
General
