Phase Alternation by Line (PAL) is the standard in the United Kingdom, much of Western Europe,
several South American countries, some Middle East and Asian countries, several African countries,
Australia, New Zealand, and other Pacific island countries. PAL uses the format of 625 picture lines
and a 50Hz lighting frequency.
CAUTION: You should change the video profile settings using a video management software.
► Perform the following steps:
1. Start the Web Interface.
2. From the tree, select Configuration >Video.
3. From the Video standard list, select the analog display standard of the region. You can select
from the following:
NTSC
PAL
NOTE: Changing the video standard requires a reboot. A dialog box appears warning you of the
changes to the video standard.
4. Click Yes to make the changes.
5. Click Apply.
6. Click OK to reboot the Edge device.
Configuring the Encoder Properties
For each video input, the S1800e series devices can send video with different sets of parameters to
different locations. The single/dual port devices support quad-stream encoding with three streams
using H.264 compression and one using MJPEG compression. The multiport devices support triple-
stream encoding provides two streams using H.264 compression and one using MPEG4
compression. You can customize each device in terms of frame rate and resolution to meet each
system requirements.
Chapter 5: Using the Web Interface for Configuration
Verint Video Intelligence Solutions
80
To Next Page
Loading...
Need help?
General
