12. In the SNMPv3 User Authentication Type list, select the authentication algorithm for SNMP
requests. You can select from the following:
No Authentication:No authentication is used.
MD5 Authentication:The Message Digest Version 5 (MD5) hash function is used to
determine that the message is from a valid source.
SHA Authentication:The Secure Hash Algorithm (SHA) has function is used to
determine that the message is from a valid source.
13. In the SNMPv3 User Auth Password box, type a password for the user.
14. In the SNMPv3 Privacy Protocol list, select the privacy protocol to encrypt the contents of the
data. You can select from the following:
No Encryption:No encryption is used.
DES Encryption:The Data Encryption Standard (DES) algorithm is used to encrypt the
data.
AES Encryption:The Advanced Encryption Standard (AES) algorithm is used to encrypt
the data.
15. In the SNMPv3 Privacy Password box, type a password for the privacy protocol.
16. Click Apply.
17. Click Close.
NOTE: The device will reboot.
Audio Properties
The S1801e, S1802e, S1808e-A and S1816e-A supports bi-directional audio: audio input and
output. Audio input allows you to capture audio signals from a camera, provided that it supports
audio, at the same time it captures video.
Currently, the S1800e series devices support the following audio formats:
Codec
Sampling Frequency Bits per Sample Bitrate
PCM (no compression) 8 kHz 16bits/data 28 kbits/sec (8kHz)
G.711/μ-Law (8 bits) 8 kHz 14 bits signed/data 64 kbits/sec
NOTE: The S1816e-SPand S1816e-SR models do not support audio.
Setting the Audio Sampling Rate
Expressed in hertz (Hz), sampling rate is the rate at which samples of an analog signal are taken in
order to be converted into digital form. The device uses 8 kHz.
Chapter 4: Using SConfigurator for Configuration
Verint Video Intelligence Solutions
68
To Next Page
Loading...
Need help?
General
