Verint Nextiva S1808e-A User Manual

Restoring the Factory Default Settings Using SConfigurator
Use the following procedure to restore the factory default settings using SConfigurator.
► Perform the following steps:
1. Start SConfigurator.
2. Select the Units tab, then click Discover.
3. Select the device, and click Configure.
4. Click Load Default Settings.
5. Click OK.
Restoring the Factory Default Settings
If after rebooting the device still does not function the way it should, you can load the factory default
configuration. This operation will restore the factory default settings to the device and delete all user-
defined values.
► Perform the following steps:
1. Start the Web Interface.
2. From the tree, select Administration >Factory Default Settings.
3. From the Factory Default Settings panel, select one of the following:
Restore to Factory Default Settings (Partial): to keep the network settings while
restoring the default configuration.
Restore to Factory Default Settings: to restore the unit back to the factory default
configuration and remove all user settings.
4. Click Restore.
Restoring the Factory Default Settings from the Front Panel
Use the following procedure to restore the factory default settings from the front panel.
► Perform the following steps:
1. Press and hold the Reset button on the device, until the status LED flashes red very rapidly.
NOTE: It can take up to 10seconds for the system status LED to begin flashing red.
Chapter 6: Maintaining and Troubleshooting the Device
Verint Video Intelligence Solutions
108

Verint Nextiva S1808e-A Specifications

General

Brand	Verint
Model	Nextiva S1808e-A
Category	Media Converter
Language	English