Device Reboot
If the S1800e device does not function the way it should, you can reboot the device to re-initialize the
settings. To reboot the device using a video management software, refer to the user guide for
instructions.
Rebooting the Device Using SConfigurator
Use the following procedure to reboot the device using SConfigurator.
► Perform the following steps:
1. Start SConfigurator.
2. Select the Units tab, then click Discover.
3. Select the device, and click Reboot.
4. Click OK.
Rebooting the Edge Device
Rebooting the devices allows you to re-initialize the settings or apply the new parameters. If you
change a parameter that requires a reboot and decline to reboot the Edge device immediately, the
icon will flash red until the Edge device is rebooted. To reboot the device using a video management
software, refer to the user guide for instructions.
► Perform the following steps:
1. Start the Web Interface.
2. From the Quick Launch bar, click .
Rebooting the Device from the Front Panel
Use the following procedure to reboot the device from the front panel.
► Perform the following steps:
1. On device, press Reset.
Factory Default Settings
If after rebooting the device still does not function the way it should, you can load the factory default
configuration. This operation will restore the factory default settings to the device and delete all user-
defined values.
Device Reboot
107
www.verint.com/video_solutions
To Next Page
Loading...
Need help?
General
